Arb 3915020 Manuel d'utilisateur

05/01/04 Page 1 of 9 3783077 If you have any queries regarding the installation of this product please contact the distributor from whom it was purch

05/01/04 Page 2 of 9 3783077 USE PART No QTY DESCRIPTION BUFFER FITTMENT 6151128 16 NUT FLANGE M6 31621

05/01/04 Page 3 of 9 3783077 ASSEMBLY SEQUENCE FOR WINCH BUMPER. 1. 1. Remove the bumper bar from the vehicle. 2. Position the lower buffer on

05/01/04 Page 4 of 9 3783077 7. 7. Push the top chrome tube through the hole in the buffer and fasten using the M12 x 40mm bolts, washers and spri

05/01/04 Page 5 of 9 3783077 10. 11. By undoing the screws on the side of the control box, remove the top cover and replace the three short leads w

05/01/04 Page 6 of 9 3783077 13. (If not fitting winch) 17. Wrap rubber extrusion around the winch cover and trim excess. 18. Place spacer washers o

05/01/04 Page 7 of 9 3783077 16. 24. The rubber extrusion contains a support section to assist in the moulding. Remove this section by tearing at o

05/01/04 Page 8 of 9 3783077 19. 28. Using a sharp knife cut the excess rubber in line with the inside end of the wing. Only cut the inside excess,

05/01/04 Page 9 of 9 3783077 22. (If fitting with winch) 34. Feed the winch cable through the roller fair lead. Mount the hook to the end of the cabl