Arb RD102 Manuel d'utilisateur télécharger pdf (Page 41)

6 Testing & Final Assembly

Figure 28.

6.2.1 A Reinstalling ‘C’ Clip Retained Shafts

c Remove the long cross shaft.

Figure 29.

c Rotate the differential until the ‘C’ clip access window is in full view.

c Insert both axles fully into the housing and gently tap them inward

as far as they will go.

NOTE : To prevent damage to the oil seals, support the weight

of the axle shaft when inserting them.

c Using needle nosed pliers, insert one of the ‘C’ clips onto the

groove in the axle shaft by sliding it between the spider block and a

side gear. (Refer to Figure 30.)

NOTE : You may have to slide the axle shaft outward very

slightly to adequately line up the groove.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46

Pas de commentaire

Arb RD102 Manuel d'utilisateur Page 41