Arb RD137 Manuel d'utilisateur télécharger pdf (Page 22)

4 Installing the Air Locker

4.10 Setting up the Bulkhead Fitting

c Apply thread sealant to the threads of the bulkhead body.

c Screw the bulkhead body into the tapped hole, and tighten.

c Wipe the area clean of any excess thread sealant (inside and

outside of the housing).

c From the outside of the housing, assemble the small O-ring over

the top of the short length of seal housing tube protruding through

the bulkhead fitting.

c While holding the seal housing tube into the bulkhead fitting, insert

the small drilled end of the center compression nut over the

extended tube as shown in the assembly diagram (Fig.14.), and

screw it into the bulkhead body, and lightly tighten.

NOTE : Be sure to insert the correct end of the center

compression nut into the bulkhead body. The thread

has been partially relieved on the bulkhead side of the

center compression nut to visually identify its

orientation. (Fig.14.)

Figure 14.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 37 38

Pas de commentaire

Arb RD137 Manuel d'utilisateur Page 22