Arb RD142 Manuel d'utilisateur télécharger pdf (Page 14)

3 Installing the Air Locker

 Cover the drive pinion area with a rag to protect it from metal filings.

 Secure the differential housing to the work bench.

 Drill an 11.2mm [7/16”] diameter hole through the differential

housing square to the outside surface.

 Tap the hole from the outside using a ¼”NPT thread tap.

 Remove any sharp edges that may chip off from around the hole

and fall into the housing.

 Very carefully, remove the rags and inspect with a service light

inside the housing to insure no metal filings are left behind.

3.4 Final Air Locker Assembly

 Clean all parts of the differential assembly, paying particular

attention to the seal housing journal.

 Place the Air Locker into the differential housing and install the

bearing caps.

NOTE : Be sure to check that the bearing caps are on the

correct sides of the third member and are correctly

aligned.

 Insert the bearing cap bolts and hand tighten.

NOTE : Before attempting to install the adjuster nuts, make

sure the threads on the inside of the bearing caps and

differential housing are perfectly aligned. If they are

not, the threads could be stripped.

 Insert and lightly hand tighten the adjuster nut supplied with the Air

Locker kit into the ring gear side bearing cap.

NOTE : You should feel no backlash between the ring and

pinion gears once the adjuster nut tightens.

 Reverse the adjuster nut (counterclockwise) ¼ turn.

 Insert the original adjuster nut onto the opposite side of the

differential and tighten with the appropriate adjuster nut wrench.

NOTE : You should now feel some backlash between the ring

and pinion gears. If not, there might be a clearance

problem which is binding the carrier. Re-check the

clearance.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Pas de commentaire

Arb RD142 Manuel d'utilisateur Page 14