Arb RD20 Manuel d'utilisateur télécharger pdf (Page 14)

4 Installing the Air Locker

4.1 Installing the Carrier Bearings

c With the Air Locker well supported in an arbor press, apply a thin

film of high pressure grease to the ring gear side bearing journal,

and assemble the newly established shim pack onto the bearing

journal.

c Press the tapered roller bearing cone onto the bearing journal of

the differential carrier until the bearing seats firmly against the shim

pack.

NOTE : Never re-use any bearings which are damaged or

worn.

c Invert the Air Locker and apply a thin film of high pressure grease

to the seal housing side bearing journal.

c Press the bearing cone which was supplied with the Air Locker kit

onto the bearing journal, taking care not to damage the o-ring

grooves. (Figure 6.)

Figure 6.

NOTE : Do not add any shims between the seal housing

bearing and the bearing seat.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Pas de commentaire

Arb RD20 Manuel d'utilisateur Page 14