Arb RD32 Manuel d'utilisateur télécharger pdf (Page 13)

3 Bench Measurement

3.2 Calculation & Selection of Shims

The thickness of the shim pack required for the Air Locker (shown as

‘D’ in Figure 5.) can now be determined by substituting the

measurements taken into the following equation.

A + B – C = D

HINT : If your calculations are correct then the following

equation will also be true:

A + B – C – D = ZERO

To make a shim pack to match the measurement you calculated as ‘D’

you can:

§ remove shims from the shim pack you measured as ‘B’.

§ add some shims from the shim pack you removed from the right

hand side of the original differential to the shim pack you

measured as ‘B’.

§ supplement your original shims with shims purchased from your

vehicle manufacturer.

§ Use a universal shim kit available from most drive train

specialists.

NOTE : Never re-use any shims which are damaged or worn.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Pas de commentaire

Arb RD32 Manuel d'utilisateur Page 13