Arb RD75 Manuel d'utilisateur télécharger pdf (Page 19)

3 Installing the Air Locker

 While holding the seal housing tube into the bulkhead fitting, insert

the small drilled end of the center compression nut over the

extended tube as shown in the assembly diagram (Fig.13.), and

screw it into the bulkhead body, and lightly tighten.

NOTE : Be sure to insert the correct end of the center

compression nut into the bulkhead body. The thread

has been partially relieved on the bulkhead side of the

center compression nut to visually identify its

orientation. (Fig.13.)

Figure 13.

NOTE : Excessive tightening of the center compression nut is

not necessary to form a good seal around the tube

and may damage the O-ring, the seal housing tube, or

the threads of the compression nut.

NOTE : Make sure the seal housing tube is all of the way into

the center compression nut while you are tightening

it.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Pas de commentaire

Arb RD75 Manuel d'utilisateur Page 19