Arb RD82 Manuel d'utilisateur télécharger pdf (Page 24)

4 Installing the Air Locker

Figure 14.

NOTE : Excessive tightening of the center compression nut is

not necessary to form a good seal around the tube

and may damage the O-ring, the seal housing tube, or

the threads of the compression nut.

NOTE : Make sure the seal housing tube is all of the way into

the center compression nut while you are tightening

it.

 Again check that no part of the seal housing tube comes in contact

with the moving differential components. Less than 8mm [5/16”]

should be considered too little clearance. Gently bend the tube

away from moving parts if necessary.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Pas de commentaire

Arb RD82 Manuel d'utilisateur Page 24