Arb RD83 Manuel d'utilisateur télécharger pdf (Page 6)

1 Introduction

1.2 Tool-Kit Recommendations

Below is a list of tools and supplies you may need to complete this

installation. Requirements for your vehicle may vary. Please consult

your vehicle service manual for additional recommendations.

1.2.1 Tools

c Standard automotive sizes (metric and/or imperial) of sockets,

wrenches, Alan keys, and drills.

c A dial indicator or other suitable measuring tool for checking ring &

pinion backlash.

c A standard automotive feeler gauge.

c A razor knife to cut the nylon tubing.

c A differential housing spreader, to facilitate removal, installation and

preloading of the carrier.

c A torque wrench. (See vehicle service manual for required torque

range.)

c A lubricant drain reservoir.

c Suitable measuring tools to measure a differential for pre-load

and/or backlash shimming. (See Section 3.3)

c A 11.2mm [7/16”] drill and ¼” NPT tap for bulkhead fitting

installation.

c An automotive bearing puller (2 jawed is recommended) or a

differential carrier bearing puller.

c A bearing press or arbor press.

1.2.2 Supplies

c Thread lubricant/sealant compound for pressure fittings

(e.g., LOCTITE #567 Teflon paste)

c Thread locking compound (e.g., LOCTITE #272)

c Either a replacement gasket, or gasket sealant, for your differential

cover.

c A sufficient volume of differential oil to completely refill your

housing. (see the ARB Air Locker Operating and Service Manual

for recommended lubricants)

c A soap and water mixture to test for air leaks.

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Pas de commentaire

Arb RD83 Manuel d'utilisateur Page 6