Arb 3415120 Manuel d'utilisateur télécharger pdf (Page 15)

Last Rev Date: 17 SEPTEMBER 2008 Page 15 of 20 Fitting instructions# 3783312

FITTING MOUNT BRACKETS

Hint: Check that the M12 long bolts screw

freely into the clevis nut threads before

assembly.

Packers are supplied to compensate for

body to chassis variation if required

66. Insert clevis bolt with spring, large flat

washers and rectangular 8mm plate

washer through hole in mount bracket

rear flange as shown. Then loose fit

mount brackets to chassis.

67. Secure using existing OE M10 flange

nuts, but do not do up tight.

68. Replace tow hooks using existing bolts

but do not do up tight.

69. Insert clevis nut into rectangular hole in

outboard face of chassis, with the notch in

nut facing toward front of vehicle and

located at the outboard edge of chassis.

NOTE: If KDSS is fitted to vehicle the LHS nut

will have to be loaded to the chassis hole from

the inboard face (engine bay side).

70. The nut when positioned has a slot which

should snugly fit and locate the nut on the

outboard edge of the rectangular chassis

hole. The nut should protrude

approximately 7mm. Screw the clevis bolt

into the clevis nut, do not tighten yet.

71. Tap the outer flange of the mount

brackets until they are hard up against the

tow hook mount area. Nip up the lowest

outboard nut on each bracket. Brackets

should be about 935mm apart

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Arb 3415120 Manuel d'utilisateur Page 15