Arb 3415120 Manuel d'utilisateur télécharger pdf (Page 9)

Last Rev Date: 17 SEPTEMBER 2008 Page 9 of 20 Fitting instructions# 3783312

REMOVAL OF BUMPER Cont.

26. If fitting 12000lb winch, undo bolt

securing the brace attached to the

centre of grille cross member. See step

61 for picture of bracket.

27. Remove grille from bumper cover by

releasing plastic tabs as shown

28. Remove fog light brackets and set aside,

these will not be reused

29. Remove headlight washer circuit if fitted

and retain for reuse.

30. Remove fog light loom, if fitted, for reuse.

Note, the connections will need to be

removed to fit through the bull bar holes.

31. Place bumper face up on a bench or

similar so there is sufficient access for the

cutting operation

32. Using a jigsaw, carefully cut along the

edge of the masking tape.

33. Remove burrs from the cut edge of the

bumper, then set aside on the soft non

abrasive surface.

Cutting edge

Warning: Cutting

operations can result in

flying debris, safety glasses

should be worn. Work

safely; keep fingers clear of

cuttin

blade.

Cutting line

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Pas de commentaire

Arb 3415120 Manuel d'utilisateur Page 9