Arb RD129 Manuel d'utilisateur télécharger pdf (Page 18)

4 Installing the Air Locker

c Remove any sharp edges that may chip off from around the hole

and fall into the housing.

c Very carefully, remove the rags and inspect with a service light

inside the housing to insure no metal filings are left behind.

4.6 Modifying the Bearing Cap

c A hole must be drilled in the seal housing bearing cap for the seal

housing tube to pass through.

Figure 8.

NOTE : Take time and double check when drilling, as bearing

caps are custom fitted to the axle housing and cannot

be replaced.

c Hold the seal housing end of the bearing cap steady for drilling in a

vice clamp.

NOTE : Do not apply too much clamping pressure with the

vice. The bearing cap may be damaged.

c Using a pedestal drill, drill a 6mm [¼’’] hole through the bearing

cap, in the position shown, so that the drill is against the edge of

the bearing stop. (Fig.8.)

c Debur both ends of the drilled hole to remove any sharp edges.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Pas de commentaire

Arb RD129 Manuel d'utilisateur Page 18