Arb RD129 Manuel d'utilisateur télécharger pdf (Page 8)

2 Removing the Existing Differential

2.4 Marking the Bearing Caps

c Using a pointed center punch, gently mark the differential housing

and the bearing caps in a way that will enable you to correctly

position the cap during reassembly. (Fig.1.)

Figure 1.

2.5 Checking the Current Backlash Amount

IMPORTANT:

This step is a precautionary measure recommended by ARB due

to the fact that some after market ring and pinion sets have been

manufactured to run with different backlash settings than those

specified by your vehicle manufacturer. Although ARB must

recommend you set backlash according to your service manual

guidelines, we also advise that you compare the backlash

measurements taken here to the recommended backlash settings

in your vehicle service manual. Measurements found to be

outside of your service manual recommendations may indicate

the need to deviate from those settings in order to achieve quiet

running with a good contact mark.

Refer to your vehicle service manual or your local authorized

ARB installer for more information.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Pas de commentaire

Arb RD129 Manuel d'utilisateur Page 8