Arb RD110 Manuel d'utilisateur télécharger pdf (Page 19)

3 Installing the Air Locker

3.7 Installing the Bulkhead Fitting

c To obtain an oil tight seal, apply a thread sealant to the threads of

the bulkhead body, screw it into the bulkhead port (from the

outside), and tighten.

c Wipe the area clean of any excess thread sealant (inside and

outside of the housing).

3.8 Installing the Seal Housing

c Apply a thin film of high pressure grease to the outside of the

tapered roller bearing cup supplied with the Air Locker.

c Using a bearing press or arbor press, press the bearing cup into the

seal housing (narrow edge first) until it stops at the end of the bore.

NOTE : Do not install the bearing cup upside down. Refer to

Figure 9. for the correct installation direction.

Be careful not to bend the seal housing tube or

damage the O-ring grooves.

Figure 9.

c Make sure the seal housing tube and the grooves of the seal

housing are clean and free from any contaminants (e.g., water, dirt,

metal filings, etc.).

c Inspect the seal housing O-rings (supplied) for dirt, damage or

other conditions which might cause leaks.

c Generously lubricate the O-rings with oil prior to assembly, then

insert them into the grooves of the seal housing.

NOTE : When assembling the O-rings, be careful not to leave

them twisted when seated in the grooves as this could

cause excessive wear and leakage.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Pas de commentaire

Arb RD110 Manuel d'utilisateur Page 19