Arb RD110 Manuel d'utilisateur télécharger pdf (Page 22)

3 Installing the Air Locker

3.10 Setting Up the Bulkhead Fitting

c Insert the end of the seal housing tube into the bulkhead fitting and

hold it to its full depth.

c From the outside of the housing, assemble the small O-ring over

the top of the small length of seal housing tube that can be seen

inside the bulkhead fitting.

c While still holding the seal housing tube at depth, insert the small

drilled end of the center compression nut over the extended tube as

shown in the assembly diagram (Fig.12.), and screw it into the

bulkhead body, and tighten.

Figure 12.

NOTE : Be sure to insert the correct end of the center

compression nut into the bulkhead body. The thread

has been partially relieved on the bulkhead side of the

center compression nut to visually identify its

orientation. (Fig.12.)

NOTE : Excessive tightening of the center compression nut is

not necessary to form a good seal around the tube

and may damage the O-ring or the threads of the

compression nut.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

Pas de commentaire

Arb RD110 Manuel d'utilisateur Page 22