Arb RD147 Manuel d'utilisateur télécharger pdf (Page 13)

3 Installing the Air Locker

NOTE : Make sure any grinding dust, filings or drill chips left

behind by cutting the drainage slots is completely

cleaned out of the housing.

 Check that the axle air vents are clear and working correctly.

3.2

Installing the Carrier Bearings

 Apply a thin film of high pressure grease to both bearing journals of

the Air Locker to prevent seizing.

 Using a bearing press or arbor press, press one of the bearing

cones (supplied with the Air Locker kit) onto one bearing journal of

the Air Locker (refer to Figure 5.) until the bearing seats firmly

against the bearing journal shoulder.

Figure 5.

 Invert the Air Locker and press the other tapered roller bearing

cone onto the opposite bearing journal of the differential carrier until

the bearing seats firmly against the bearing journal shoulder.

NOTE : Do not add any shims between the bearings and the

bearing seat. Shimming of the Air Locker will be

performed with the supplied shim kits and/or the OE

master shims (if any) on the outside of the carrier

bearings.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Pas de commentaire

Arb RD147 Manuel d'utilisateur Page 13