Arb RD106 Manuel d'utilisateur télécharger pdf (Page 27)

4 Installing the Air Locker

Figure 17.

4.7.3 Notching the Bearing Cap

c Use a soft jawed vise clamp to hold the bearing cap steady.

c Using a 6.35mm [¼’’] rat-tailed file. File out a notch in the bearing

cap from the closest edge until an adequate notch has been cut

around the position of the punch mark. (Fig.18.).

Figure 18.

c File a chamfer around the inside edge of the notch to remove any

sharp edges from the notch that may chip-off and fall into the

housing.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Pas de commentaire

Arb RD106 Manuel d'utilisateur Page 27