Arb RD113 Manuel d'utilisateur télécharger pdf (Page 6)

1 Introduction

1.2

Tool-Kit Recommendations

Below is a list of tools and supplies you may need to complete this

installation. Requirements for your vehicle may vary. Please consult

your vehicle service manual for additional recommendations.

1.2.1

Tools

 Standard automotive sizes (metric and/or imperial) of sockets,

wrenches, Alan keys, and drills.

 A dial indicator or other suitable measuring tool for checking ring &

pinion backlash.

 A standard automotive feeler gauge.

 A razor knife to cut the nylon tubing.

 A differential housing spreader, to facilitate removal of the carrier.

(not required on aluminum housings)

 A torque wrench. (See vehicle service manual for required torque

range.)

 A lubricant drain reservoir.

 Suitable measuring tools to measure a differential for pre-load

and/or backlash shimming. (See Section 3.3)

 A 11.2mm [7/16”] drill and ¼” NPT tap for bulkhead fitting

installation.

 An automotive bearing puller (2 jawed is recommended) or a

differential carrier bearing puller.

 A bearing press or arbor press.

1.2.2

Supplies

 Thread lubricant/sealant compound for pressure fittings

(e.g., LOCTITE #567 Teflon paste)

 Thread locking compound (e.g., LOCTITE #272)

 Either a replacement gasket, or gasket sealant, for your differential

cover.

 A sufficient volume of differential oil to completely refill your

housing. (see the ARB Air Locker Operating and Service Manual

for recommended lubricants)

 A soap and water mixture to test for air leaks.

1 2 3 4 5 6 7 8 9 10 11 ... 41 42

Pas de commentaire

Arb RD113 Manuel d'utilisateur Page 6