Arb RD116 Manuel d'utilisateur télécharger pdf (Page 21)

3 Installing the Air Locker

Figure 11.

 Consult your vehicle manufacturer’s service manual to determine

the carrier bearing pre-load amount specified for your vehicle.

 Add the specified pre-load amount to the measurement taken with

the feeler gauge to determine a shim amount for ‘D’ in Figure 9.

PRE-LOAD + END FLOAT = SHIM PACK

 Create a shim pack ‘D’ from the shims supplied with your Air

Locker.

NOTE : Do not add shims between the bearing cone and the

bearing seat and NEVER machine the Air Locker.

 Remove the Air Locker from the axle housing.

 Install the shim pack ‘D’ between the ARB master shim and the

seal housing as shown in Figure 9.

 Spread the differential housing again (Refer to Section 2.6).

 Re-install the Air Locker into the axle housing.

NOTE : If the Air Locker is too tight to fully install then the

spreader tension may need to be increased. Do not

spread the housing more than 0.50mm [0.020”].

 Rotate the seal housing until the tube is positioned in the center of

the oil drainage notch of the axle housing. (Fig.12.)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Pas de commentaire

Arb RD116 Manuel d'utilisateur Page 21