Arb RD12 Manuel d'utilisateur télécharger pdf (Page 20)

4 Installing the Air Locker

4.6 Marking the Bearing Cap for Tube Clearance

With the Air Locker in place and less than 0.5mm of backlash, an

accurate measurement for the seal housing tube clearance can be

made.

NOTE : Take time and double check when taking your

measurements, as bearing caps are custom fitted to

the axle housing and cannot be replaced.

c With the seal housing tube pointing straight out, measure the

distance from a fixed position inside the differential housing to the

center of the seal housing tube. (Fig.10.)

Figure 10.

c Record your findings and recheck for accuracy.

c Remove the bearing cap from the ring gear side of the differential.

c Remove the Air Locker from the differential housing.

c Install the seal housing side bearing cap and hand-tighten the

bearing cap bolts.

NOTE : It is very important to make sure the punch marks

made on the differential housing while removing the

differential are matched to the punch marks on the

bearing cap. The bearing cap must be replaced

exactly as it was removed. (Refer to section 2.4)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Pas de commentaire

Arb RD12 Manuel d'utilisateur Page 20