Arb RD05 Manuel d'utilisateur télécharger pdf (Page 6)

1 Introduction

1.2

Tool-Kit Recommendations

Below is a list of tools and supplies you may need to complete this

installation. Requirements for your vehicle may vary. Please consult

your vehicle service manual for additional recommendations.

1.2.1

Tools

 Standard automotive sizes (metric and/or imperial) of sockets,

wrenches, Allan keys, and drills.

 A dial indicator or other suitable measuring tool for checking ring &

pinion backlash.

 An adjuster-nut wrench. (See your vehicle service manual.)

 A razor knife suitable for cutting nylon tubing.

 A torque wrench. (See your vehicle service manual for the required

torque range.)

 A lubricant drain reservoir.

 A 11.2mm [7/16”] drill and ¼”NPT tap for bulkhead fitting

installation.

 An automotive bearing puller (2 jawed is recommended) or a

differential carrier bearing puller.

 A slide hammer.

 A bearing press or arbor press.

1.2.2

Supplies

 Thread lubricant/sealant compound (e.g., LOCTITE #567)

 Thread locking compound (e.g., LOCTITE #272)

 A gasket sealant or replacement gasket for your third member.

 A sufficient volume of differential oil to completely refill your

housing. (See the ARB Air Locker Operating and Service Manual

for recommended lubricants)

 A soap and water mixture to test for air leaks.

 Teflon paste.

1 2 3 4 5 6 7 8 9 10 11 ... 37 38

Pas de commentaire

Arb RD05 Manuel d'utilisateur Page 6