Arb RD102 Manuel d'utilisateur télécharger pdf (Page 15)

3 Installing the Air Locker

c If no drainage slot is present at the upper left-hand side (refer to

Fig.6.) of the housing at all, then a slot (not a hole) will have to be

created here as clearance for the seal housing tube

(Refer to Section 3.8 Reinstalling the Bearing Caps).

c If drainage exists but is inadequate then slots or holes should be

cut into the housing on the upper and lower side of the tubes where

required.

NOTE : Figure 9. shows upper and lower drainage slots cut

into a bearing seat which had no existing drainage at

all before modification.

Figure 9.

c Remove any sharp edges left behind by the modifications that

could break off and fall into the cavity.

c Make sure any grinding dust, filings or drill chips left behind by

cutting the drainage slots are completely cleaned out of the

housing.

c Check that the axle air vents are clear and working correctly.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 45 46

Pas de commentaire

Arb RD102 Manuel d'utilisateur Page 15