Arb RD107 Manuel d'utilisateur télécharger pdf (Page 36)

5 Installing the Air System

c To attach the air line to the push-in fitting of the solenoid; insert the

line firmly into the fitting, pull outward on the flange of the fitting

while holding the line as far into the fitting as possible, and then

gently pull outward on the air line to clamp the line in place.

5.3 Connection to the Bulkhead Fitting

c Trim the air line to length using a sharp knife.

c Insert the support spring over the end of the air line - small end first.

(Fig.24.)

c Insert the outer compression nut over the air line.

c Insert the 5mm [0.197”] ferrule over the end of the air line. Leave

approx. 5mm of tubing between the ferrule and the end of the tube.

Figure 24.

c Insert the support tube all the way into the end of the air line.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Pas de commentaire

Arb RD107 Manuel d'utilisateur Page 36