Arb RD113 Manuel d'utilisateur télécharger pdf (Page 14)

3 Installing the Air Locker

3.3

Approximate Backlash Shimming

In order to reproduce a similar pre-load and ring and pinion backlash

in your Air Locker to that of your original differential, measurements

need to be taken so that a shim thickness can be calculated.

 Secure the original differential to a work bench.

 Remove the bolts that hold the ring gear in place.

 Using a plastic or copper hammer, tap in a circle around the ring

gear to separate it from the differential carrier.

Figure 6.

 Assemble the original bearing cup onto the cone of the right-hand

side of the original differential carrier.

 Using a caliper or similarly accurate measurement method

(i.e., able to take accurate measurements within 0.04mm [0.0015”]),

measure the distance from the shoulder of the outer face of the

bearing cup to the ring gear mounting face (shown as ‘A’ in Figure

6.) and record this measurement as ‘A’.

NOTE : Be sure to measure using the bearing cup that

originally came off of the right-hand side.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Pas de commentaire

Arb RD113 Manuel d'utilisateur Page 14