Arb RD127 Manuel d'utilisateur télécharger pdf (Page 29)

4 Installing the Air System

NOTE : To remove the air line from the push-in fitting; pull

outward on the flange of the fitting, push the air line

as far into the fitting as possible and hold, push

inward on the flange, and then pull the air line free of

the fitting.

4.3

Connection to the Bulkhead Fitting

 Trim the air line to length using a sharp knife.

 Insert the support spring over the end of the air line - small end first.

(Fig.21.)

 Insert the outer compression nut over the air line.

 Insert the 5mm [0.197”] ferrule over the end of the air line. Leave

approx. 5mm of tubing between the ferrule and the end of the tube.

Figure 21.

 Insert the support tube all the way into the end of the air line.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Pas de commentaire

Arb RD127 Manuel d'utilisateur Page 29