Arb RD137 Manuel d'utilisateur télécharger pdf (Page 17)

4 Installing the Air Locker

c Add the specified pre-load amount to the measurement taken with

the feeler gauge to determine a shim amount for ‘E’ in Figure 6.

PRE-LOAD + END FLOAT = SHIM PACK

c Select suitable shims from the shim kit supplied with your Air

Locker to make up a shim pack of this thickness. (Refer to section

3.2 for methods of shim adjustment).

4.5 Drilling and Tapping the Bulkhead Port

An air line port must be drilled and tapped through the differential

housing to mount the bulkhead fitting into.

c Mark a spot on the exterior of the differential housing toward the top

in an area that will be well clear of the Air Locker body, the ring

gear, and any other obstructions that could snag the seal housing

tube. (Fig.8.)

Figure 8.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Pas de commentaire

Arb RD137 Manuel d'utilisateur Page 17