Arb RD137 Manuel d'utilisateur télécharger pdf (Page 28)

5 Installing the Air System

5.3 Connection to the Bulkhead Fitting

c Trim the air line to length using a sharp knife.

c Insert the support spring over the end of the air line - small end first.

(Fig.17.)

c Insert the outer compression nut over the air line.

c Insert the 5mm [0.197”] ferrule over the end of the air line. Leave

approx. 5mm of tubing between the ferrule and the end of the tube.

Figure 17.

c Insert the support tube all the way into the end of the air line.

HINT : If the support tube is too difficult to insert, place the

end of the air line into a cup of boiled water to soften

the tubing.

c Insert the tube end all the way into the center compression nut.

c Screw on the outer compression nut and tighten. The ferrule and

support tube are now permanently attached.

c Assemble the support spring over the outside of the outer

compression nut.

c Secure any loose sections of tube with a cable tie.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Pas de commentaire

Arb RD137 Manuel d'utilisateur Page 28