Arb RD138 Manuel d'utilisateur télécharger pdf (Page 8)

2 Removing the Existing Differential

2.4 Marking the Bearing Caps

c Using a small pointed center punch, gently mark the bearing caps

in a way that will enable you to know which cap is ‘LEFT’ and which

cap is ‘RIGHT’, which way is ‘UP’ and which way is ‘DOWN’.

(Fig.1.)

c Mark the right hand cap in a similar way.

HINT : Many installers choose to make one punch mark on

the left hand side of the left hand bearing cap and a

similar mark on the housing at close proximity to the

cap mark. The right hand side is then designated with

two punch marks on the right hand side of the cap and

two similar punch marks on the housing.

Figure 1.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Pas de commentaire

Arb RD138 Manuel d'utilisateur Page 8