Arb RD44 Manuel d'utilisateur télécharger pdf (Page 28)

4 Installing the Air Locker

c Wipe the area clean of any excess thread sealant (inside and

outside of the housing).

c From the outside of the housing, assemble the small O-ring over

the top of the short length of seal housing tube protruding through

the bulkhead fitting.

c While holding the seal housing tube into the bulkhead fitting, insert

the small drilled end of the center compression nut over the

extended tube as shown in the assembly diagram (Fig.17.), and

screw it into the bulkhead body, and lightly tighten.

NOTE : Be sure to insert the correct end of the center

compression nut into the bulkhead body. The thread

has been partially relieved on the bulkhead side of the

center compression nut to visually identify its

orientation. (Fig.17.)

Figure 17.

NOTE : Excessive tightening of the center compression nut is

not necessary to form a good seal around the tube

and may damage the O-ring, the seal housing tube, or

the threads of the compression nut.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 45 46

Pas de commentaire

Arb RD44 Manuel d'utilisateur Page 28