Arb RD81 Manuel d'utilisateur télécharger pdf (Page 29)

5 Installing the Air System

 To attach the air line to the push-in fitting of the solenoid; insert the

line firmly into the fitting, pull outward on the flange of the fitting while

holding the line as far into the fitting as possible, and then gently pull

outward on the air line to clamp the line in place.

NOTE : To remove the air line from the push-in fitting; pull

outward on the flange of the fitting, push the air line as

far into the fitting as possible and hold, push inward on

the flange, and then pull the air line free of the fitting.

5.3

Connection to the Bulkhead Fitting

 Trim the air line to length using a sharp knife.

 Insert the support spring over the end of the air line - small end first.

(Fig.17.)

 Insert the outer compression nut over the air line.

Figure 16.

Figure 17.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Pas de commentaire

Arb RD81 Manuel d'utilisateur Page 29