Arb RD102 Manuel d'utilisateur télécharger pdf (Page 25)

3 Installing the Air Locker

3.8 Reinstalling the Bearing Caps

IMPORTANT:

The Air Locker master shim must be assembled between the

stepped side of the seal housing and the bearing cup.

NOT HAVING THE MASTER SHIM IN PLACE

HERE WILL CAUSE BEARING FAILURE.

c Using a soft instrument such as a piece of wood, bend the seal

housing tube outward and away from the position of the bearing

cap and into the drainage groove area. (Fig.17.)

Figure 17.

NOTE : The seal housing tube should lay as low in the seal

housing groove as possible.

c Install the bearing caps oriented as they were marked before they

were removed, and tighten the bearing cap bolts. It is not

necessary to torque them down at this time.

c Check that some clearance exists between the bearing cap and the

seal housing tube. If not, the bearing cap should be removed and

the tube re-bent for adequate clearance.

c Tighten all bearing cap bolts with a torque wrench to the torque

specified in your vehicle manufacturer’s service manual.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 45 46

Pas de commentaire

Arb RD102 Manuel d'utilisateur Page 25