Arb RD110 Manuel d'utilisateur télécharger pdf (Page 17)

3 Installing the Air Locker

Figure 7.

c Add the specified preload amount to the end float measurement

determined with the feeler gauge to determine a shim amount for

‘E’ (Refer to Figure 6.).

PRELOAD + END FLOAT = SHIM PACK

c Create a shim pack ‘E’ to closely match the calculated amount.

NOTE : When creating the shim pack ‘E’, use at least 0.75mm

[0.030”] of the Air Locker shim pack between the

factory shim and the bearing cup in order to prevent

the cage of the bearing from contacting the factory

shim.

To achieve this desired shim thickness you can:

• Machine down the factory shim thickness.

• Add shims between the factory shim and the bearing cup.

• Purchase new factory shims at the desired thickness.

• Use a universal shim kit available from most drive train specialists.

NOTE : Do not add shims between the bearing cone and the

bearing seat and NEVER machine the Air Locker.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Pas de commentaire

Arb RD110 Manuel d'utilisateur Page 17