Arb RD147 Manuel d'utilisateur télécharger pdf (Page 19)

3 Installing the Air Locker

3.6

Assembling the Seal Housing

Figure 9.

 Make sure the grooves and airway of the seal housing are clean

and free from any contaminants (e.g. water, dirt, metal filings, etc.).

 Inspect the seal housing O-rings (supplied) for dirt, damage or

other conditions which might cause leaks.

 Generously lubricate the O-rings with oil prior to assembly, then

insert them into the grooves of the seal housing.

NOTE : When assembling the O-rings, be careful not to leave

them twisted when seated in the grooves as this could

cause excessive wear and leakage.

 Lubricate the seal housing running surface on the Air Locker carrier

with oil. Assemble a bearing cup onto the left-hand side of the Air

Locker.

 Assemble one of the two ARB master shims (included with the Air

Locker shim kit) onto the stepped face of the seal housing with the

rounded edge of the shim facing out.

NOTE : No shims other than the single ARB master shim

should be assembled onto the seal housing at this

time.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Pas de commentaire

Arb RD147 Manuel d'utilisateur Page 19