Arb RD83 Manuel d'utilisateur télécharger pdf (Page 17)

3 Installing the Air Locker

c Assemble the new bearing cup onto the right-hand side of the Air

Locker and measure the total distance from the shoulder of the

outer face of the bearing cup to the ring gear mounting face.

(shown as ‘C’ in Fig.10.)

NOTE : The shim pack ‘D’ should not be installed at this time.

Figure 10.

c Record this measurement as ‘C’.

The thickness of the shim pack ‘D’ must be calculated to position the

ring gear seat of the Air Locker the same as the original differential

(within 0.1mm [0.004”] ).

c Use the following calculation to find the desired thickness of ‘D’:

A + B – C = D (Replacement Shim Pack)

HINT : If your calculations are correct then the following

equation will also be true:

A + B – C – D = ZERO

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Pas de commentaire

Arb RD83 Manuel d'utilisateur Page 17