Arb RD82 Manuel d'utilisateur télécharger pdf (Page 26)

5 Installing the Air System

5.1

Mounting the Solenoid

5.1.1

Connection to an ARB Air Compressor

(Fig.15.)

 Remove one of the 1/8” BSP plugs from its port in the compressor

tank.

 Apply Teflon paste to the nipple (1/8” X 1/8” BSP) and insert it into

the port and tighten.

 Apply Teflon paste to the free end of the nipple.

 Assemble the inlet port side of the solenoid (stamped with a ‘1’) onto

the nipple and hand tighten it. The solenoid should be rotated into a

position which does not obstruct any other ports on the compressor

tank.

NOTE : The solenoid exhausts compressed air through the

center of the black retaining cap when the Air Locker is

disengaged. Make sure this orifice cannot be

obstructed.

 Apply Teflon paste to the threads of the 5mm push-in fitting and

assemble it into the solenoid outlet port (stamped “2”) and hand

tighten.

Figure 15.

ARB

Air Compressor

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Pas de commentaire

Arb RD82 Manuel d'utilisateur Page 26