Arb RD82 Manuel d'utilisateur télécharger pdf (Page 8)

2 Removing the Existing Differential

 Remove the wheels and brake assembly according to your vehicle’s

service manual.

 Rotate the differential center until the cross shaft can be removed.

 Remove the cross shaft retaining pin and the cross shaft.

 Rotate the differential until the ‘C’ clip access window is accessible.

 Gently tap the axle ends inward to release the ‘C’ clips.

 Remove ‘C’ clips with needle nose pliers.

 Gently tap axles outward and remove them from the differential center.

NOTE : Rubber oil seals can be easily damaged. Support the

weight of the axle when extracting it across the edges of

the seals.

2.4

Marking the Bearing Caps

 Using a small pointed center punch, gently mark the left bearing cap in

a way which will enable you to know which cap is ‘LEFT’ and ‘RIGHT’,

and which way is ‘UP’ and ‘DOWN’. (Fig.1.)

 Mark the right hand cap in a similar way.

HINT : Many installers choose to make one punch mark on

the left hand side of the left hand bearing cap and a similar

mark on the housing at close proximity to the cap mark.

The right hand side is then designated with two punch

marks on the right hand side of the cap and two similar

punch marks on the housing.

Figure 1.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Pas de commentaire

Arb RD82 Manuel d'utilisateur Page 8