Arb RD168 Manuel d'utilisateur télécharger pdf (Page 40)

6 Testing & Final Assembly

Figure 25.

F Pull outward on the axle shaft to seat the ‘C’ clip into the side gear.

F Repeat the ‘C’ clip installation steps on the second axle shaft.

F Re-insert the long cross shaft.

F Using an automotive feeler gauge, check the maximum distance

between the axle shaft and the cross shaft. This measurement is

what is known as the end float.

F Refer to your vehicle manufacturer’s service manual for the

appropriate end float amount. ‘C’ clips may need to be substituted

with others of a different thickness to achieve correct end float if too

tight or too loose.

F Insert and tighten the retaining pin with a 5mm hex key.

F Reconnect the drive shaft to the differential drive flange.

F Reassemble the remainder of the differential assembly

(e.g., hubs, brakes, wheels, etc.) to the vehicle according to your

vehicle’s service manual.

1 2 ... 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Arb RD168 Manuel d'utilisateur Page 40