Arb RD168 Manuel d'utilisateur télécharger pdf (Page 9)

2 Removing the Existing Differential

2.4 Marking the Bearing Caps

F Using a pointed center punch, gently mark the bearing caps in a

way that will enable you to know which cap is ‘LEFT’ and which cap

is ‘RIGHT’, which way is ‘UP’ and which way is ‘DOWN’. (Fig.1.)

HINT : Many installers choose to make one punch mark on

the left hand side of the left hand bearing cap and one

similar punch mark on the housing at close proximity to

the cap mark. The right hand side is then designated

with two punch marks on the right hand side of the cap

and two similar punch marks on the housing.

Figure 1.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Pas de commentaire

Arb RD168 Manuel d'utilisateur Page 9