Arb RD84 Manuel d'utilisateur télécharger pdf (Page 26)

3 Installing the Air Locker

c Insert the free end of the seal housing tube into the bulkhead fitting

until it protrudes approximately 8mm [5/16”] through the other side.

c From the outside of the housing, assemble the small O-ring over

the top of the short length of seal housing protruding through the

bulkhead fitting.

c While still holding the seal housing tube into the bulkhead fitting,

insert the small drilled end of the center compression nut over the

extended tube as shown in the assembly diagram (Fig.18.), and

screw it into the bulkhead body, and lightly tighten.

NOTE : Be sure to insert the correct end of the center

compression nut into the bulkhead body. The thread

has been partially relieved on the bulkhead side of the

center compression nut to visually identify its

orientation. (Fig.18.)

Figure 18.

NOTE : Excessive tightening of the center compression nut is

not necessary to form a good seal around the tube

and may damage the O-ring, the seal housing tube, or

the threads of the compression nut.

NOTE : Make sure the seal housing tube is all of the way into

the center compression nut while you are tightening

it.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Pas de commentaire

Arb RD84 Manuel d'utilisateur Page 26