Arb RD84 Manuel d'utilisateur télécharger pdf (Page 8)

2 Removing the Existing Differential

2.3 Removing the Axles

IMPORTANT :

Collision damage or heavy off-road use of your vehicle in the past may

have resulted in some degree of bending in the axle. Any misalignment

of the axle tubes may result in excessive wear and/or failure of your

differential and axle shafts. ARB strongly recommends that you have

your axle assembly inspected for concentricity and straightness before

installing your Air Locker.

c Remove both of the rear wheels and brake drums/rotors according

to you vehicle manufacturer’s service manual.

c Rotate the differential carrier using the drive shaft until you have

clear access to the cross shaft retaining pin.

c Completely remove the retaining pin from the differential carrier.

c Rotate the differential carrier again until you can completely remove

the cross shaft.

c Tap the axle shafts inward to unseat the ‘C’ clips from their pockets

in the center of the differential side gears.

c Using needle nosed pliers, remove both ‘C’ clips from the

differential.

c Tap the axle shafts outward until the splines are disengaged from

the differential side gears.

c Gently slide the axle shafts out of the axle tubes until they can be

completely removed from the vehicle.

NOTE : The oil seals are delicate and can be easily damaged.

Support the weight of the axle shafts when drawing

them out of their sockets in the housing.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Pas de commentaire

Arb RD84 Manuel d'utilisateur Page 8