Arb RD158 Manuel d'utilisateur télécharger pdf (Page 19)

4 Installing the Air Locker

4.6 Reinstalling the Bearing Caps

IMPORTANT:

The ARB master shim must be assembled between the stepped

side of the seal housing and the bearing cup.

NOT HAVING THE ARB MASTER SHIM IN PLACE

HERE WILL CAUSE BEARING FAILURE.



Using a soft instrument such as a wooden drift, bend the seal

housing tube outward and away from the position of the bearing

cap. (Fig.

10.)

Figure 10.

NOTE : The seal housing tube should lay as low in the seal

housing groove as possible.



Install the bearing caps oriented as they were marked before they

were removed, and tighten the bearing cap bolts. It is not

necessary to torque them down at this time.



Check that some clearance exists between the bearing cap and the

seal housing tube. If not, the bearing cap should be removed and

the tube re-bent for adequate clearance.



Tighten all bearing cap bolts with a torque wrench to the torque

specified in your vehicle manufacturer’s service manual.

NOTE : Aluminum housings require a smaller torque amount

than a cast iron housing. Make sure you use the

correct torque for your vehicle.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 37 38

Pas de commentaire

Arb RD158 Manuel d'utilisateur Page 19