Arb RD158 Manuel d'utilisateur télécharger pdf (Page 28)

5 Installing the Air System

5.3 Connection to the Bulkhead Fitting



Trim the air line to length using a sharp knife.



Insert the support spring over the end of the air line - small end first.

(Fig.

16.)



Insert the outer compression nut over the air line.



Push the airline onto the barb on the center compression nut,

ensuring that it is pushed all the way to the end.

Figure 16.

HINT : If the tube is too difficult to push on, place the end of

the air line into a cup of boiled water to soften the

tubing.



Screw on the outer compression nut and tighten, while supporting

the center compression nut with a 3/8” spanner. The airline is now

attached to the center compression nut.

NOTE : The outer compression nut will tighten against a stop.

Over tightening will not create a better seal.



Assemble the support spring over the outside of the outer

compression nut.



Secure any loose sections of tube with a cable tie.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Pas de commentaire

Arb RD158 Manuel d'utilisateur Page 28